This document is a calibration certificate for a Data Acquisition Electronics (DAE) unit, specifically the DAE4 with serial number 480. The calibration was performed on November 11, 2024, and the certificate documents the traceability of the measurements to national standards, ensuring the physical units of measurements (SI) are accurate. The calibration procedure used was FF-Z11-002-01, which is the standard calibration procedure for Data Acquisition Electronics (DAEx).
The calibration was conducted in a controlled laboratory environment with a temperature of 22±3°C and humidity below 70%. The equipment used for calibration, including the Process Calibrator 753, is also traceable to national standards. The certificate includes the DC Voltage Measurement calibration factors and the Connector Angle, which are essential parameters for the DASY system. The certificate is valid until the next scheduled calibration.
The certificate was issued on November 13, 2024, and is identified by the certificate number 24J02Z000794. It is important to note that this certificate should not be reproduced except in full without the written approval of the laboratory.