This document presents a detailed test report, BLA-EMC-202503-A2703, focusing on radiated emission measurements and Dynamic Frequency Selection (DFS) analysis. The report outlines the test setups used for below 1GHz, 30MHz-1GHz, and above 1GHz frequency ranges, including diagrams illustrating the equipment placement and antenna configurations.
The radiated emission testing procedure is thoroughly described, covering aspects such as EUT placement, antenna height variation, polarization, and the use of peak detection and specified bandwidth settings. The report also includes test data for various modes and channels, presenting the measured levels, correction factors, limits, and detector types. The DFS section details the channel closing transmission time and the test setup used for DFS analysis, referencing the relevant standards and procedures.
The report concludes with a pass/fail determination based on the test results, providing a comprehensive assessment of the device's compliance with the applicable regulatory requirements. Specific test modes and polarities are noted, along with the equipment used during testing.